Manufacturer of World Class Portable Air Conditioners & Environmental Control Units

The condensate pump option allows for removal of moisture from the evaporator coil
drain pan through a pump and an extended discharge tube. This option is used in place
of a standard condensate bottle.

Adds heating elements for a true HVAC system.

Enables removal of extremely small particles from the supply air. This option includes
the HEPA filter, pre-filter, and a motor and pulley upgrade.

The humidifier option includes a high capacity electronic steam humidifier, contactor,
and unit mounted control system with humidistat, sensor, and circuit breakers for unit
and humidifier. (*It is strongly recommended that units with humidifiers have a
condensate removal pump).

Senses return air temperature for fan speed selection. (*Available on direct drive units
only)

Enables operation of cooling mode when outside air is less than 50° F through
electronic outdoor motor control.

Allows the unit to operate at a set temperature and hold that temperature to within
+/- 1.5° F (1° C). Model PC1 uses a Johnson Control system and can operate down to
55° F. Model PC2 uses a microprocesser control system and can operate down to 50° F
with a reduced air flow. PC2 is designed for use in conjunction with backoffice
environmental control systems.

Humidity control and mold remediation.

Two pieces of 8 foot standard non-insulated duct for ducting of the condenser or
evaporator air.

The Air Rover supply air plenum is an installation accessory for ducting the supply air of
an Air Rover portable air conditioner. For use with XLP, WCXLP, SL, WCSL, HT, DS, MP,
MPHT and MPDS models.

The Air Rover return air plenum is an installation accessory for ducting the return air of
an Air Rover portable air conditioner. For use with XLP, WC, SL, HT, and DS models.